T600 Mini Gun
Another cool free file from http://www.cadnav.com/
- Downloads
- 327
- Likes
- 38
- Rating
- 0
19 models
Another cool free file from http://www.cadnav.com/
This is a wall-mount bracket for the GL-iNET MT6000 Flint 2 router. While the router does come with mounting holes, this: Offsets the router from the wall an extra 8mm to allow cables to go through a wall pass-through and be routed…
Based on jtpeyton Digitrax Throttle Dimensions. I needed to change the bottom to allow access to the Loconet Cable port (because I use a tethered system), and the lanyard attachment to fit in the holder for the Digitrax DT600 throttle. It…
Half height pcie bracket for NVIDIA Quadro K1200 NVS510 P600 P620 P1000 T600 T1000
Yamaha XT600E Secondary carb butterfly valve needs 7mm opening in primary carburator slide prior to it's opening. This tool is to make synchronization adjustment easier. Just slide this tool under the carburator slide, obviously flat side…
Under-shelf mounting brackets for the GL.iNet GL-MT6000 (Flint 2) WiFi router Mount your Flint 2 under a shelf or table. This pair of brackets uses locking clips to hold the router securely while still allowing quick removal for…
Full height pcie bracket for NVIDIA Quadro K1200 NVS510 P600 P620 P1000 T600 T1000
I created this wall mount for the Motorola T600 set that I picked up at Costco. This version includes screw holes that fit an M4 screw or similar and a separate model that is designed for Command strips (small).
I printed this with PETG to help make the part that clips into the walkie more flexible but PLA should work fine too
I cannot find swingarm bolt cover for my Honda Shadow VT600 1988, so I created mine. They are very simpli and fit snug. On my model the right swingarm hole is 0,15mm biger than left, so these two parts on model are not identical. Have…
This is a replacement panel for the Thermaltake T600 tower pc case. The case comes with a second panel to use with the Thermaltake LCD, but that screen is much smaller. This bezel is designed to match the clips and protrusions on the pc…
HSW Compatible mounting bracket for the Motorola T600 Walkie Talkies.
ORGANIZZATORE GT600 Realizzato: www.webtessitore.it IMPOSTAZIONE DI STAMPA Stampante 3D: Combo Anycubic Kobra S1 Laser: Mecpow X3Pro 10W
I lost the endcap for my swing arm, so I designed my own. It's nearly identical, and with a slight sanding job, some filler, and spray paint, it can look pretty decent. I have also uploaded the Inventor file in case you want to make any…
Small case I made for a project. Can be refitted depending on the needs.
For the T-Nuts look at: Skadis T-Nut. By default the holes are made for M2.5 version. There are no embedded alignment guides at the back of model, if you need them use printed ones from Skadis T-Nut Mount Anything on a Skådis Board .…
My Kaiweets ST600Y has become my go-to handheld multimeter, so I keep it close at hand in this holder that holds securely but allows virtually effortless removal and replacement. This holder is sized just right to allow the meter to slip…
Similar to my previous design I uploaded, but this one has a cutout for a TEMT6000 Ambient Light Sensor.
I created this wall mount for the Motorola T600 set that I picked up at Costco. This version includes screw holes that fit an M4 screw or similar and a separate model that is designed for Command strips (small).