14 models
I Wanted to double sided tape it so I needed a version without the reinforcement behind. So I've slice it in PrusaSlicer. And I've print it at 102% (When you play with scale more than once in prusaSlicer this scale add up! be sure to…
Print approx. €2.28–€2.79 excl. taxPreliminary estimate for one variant
The Velcro for the soft shell holders is just a square sheet and does not fit the receiver properly. This allows me to use a silver sharpie to mark the back of the Velcro so I can cut it to fit the receiver (even leaving a cutout for the…
If you would like to show some gratitude for this model and encourage me to create more, you can leave a tip for me via PayPal at https://www.paypal.com/paypalme/Arogen67 . Thanks. Estes released model rocket #1301 - R2-D2 Robot Hero in…
This doesn't need supports, it leaves lots of room for airflow throughout the bottom, and provides 6 mounting holes for flexible options. Pick any two. The base is oversized enough that this isn't a tight fit, and the cables can exit…
This 3D-printed bolt-release shroud is designed to be installed beneath the bolt-release latch of first-generation Beretta 1301 Tactical, Beretta 1301 Competition, and Beretta A400 shotguns. Its purpose is to help prevent unintended…
Clip für den Sitz des W208 zur Befestigung der hinteren Verkleidung. Muss als Spiegelteil für die Gegenseite gedruckt werden.
Just a simple tweak to use for other things
On my Toyota Sera, my clutch pedal's cushion has long dried and crumbled away. I took some measurements and printed a TPU replacement to place on my pedal. It shares a part number with a wide variety of Toyota vehicles . Print in TPU with…
If you would like to show some gratitude for this model and encourage me to create more, you can leave a tip for me via PayPal at https://www.paypal.com/paypalme/Arogen67 . Thanks. The Estes #1301 R2-D2 model rocket is a cool model…
Replacement part for the original battery. Put a stock Hoverboard Battery on the bike instead of the original!
Build a door open counter and alarm sensor with WisBlock Reed relays are often used for contactless switching in many applications. The reed relay is normally open, but when a magnet is getting close to it, the relay contacts will close.…
On the plastic insert, I made a smaller hole that serves as the nozzle, smaller than the original size. It may be sufficient for some users, but it is primarily intended as a guide for possible further enlargement using a knife or a file.…
for the new Infantry squad vehicle for the US ARMY M1301A0 drivetrain selector switch
Clip für den Sitz des W208 zur Befestigung der hinteren Verkleidung. Muss als Spiegelteil für die Gegenseite gedruckt werden.
