Counting matching models…
A simple gauge pod for the Nissan S13 that mounts below the dash. It replaces the oem vent assembly. fits 52mm gauges and 60mm gauges My design is a straight replacement of the oem vent assembly. no cutting, no drilling, 100% reversible.…
a radiator support bracket, fits Nissan S13 / 180SX / 200SX / 240SX probably also other 90s Nissans
a full set of fuel line holders to replace the rusty and brittle oem clips on your 180sx/200sx/240sx Nissan S13 4 Versions: oem replacement oem replacement but without the evap / fuel tank venting line Version with additional brake line…
I had them uploaded on Shapeway's website because it was the only website for sharing 3D prints back then, and had them for FREE download..it seems they removed this option now and because i get a lot of messages through the years i am…
another wiper pivot replacement design. two piece for prints without support.
The lower bracket that holds the control lever. it fits but not properly. it's just a prototype
Mounting Base Counterplate and Clamp uses M8 allthread with a welded tab added Versions without Nissan and 200SX Features
Did you remove your fuse box from the engine bay and are now realizing that the oem coolant reservoir was mounted to that fuse box? Here is your solution!
small clip on the sides of the trunk
Wiring grommet for right side of the S13 with bigger hole to fit 50mm2 battery wiring, print with some flexible filament like TPU or TPE.
If you have S13 and the measured diameter what is shown on the picture is 57-57,4mm, this cap fits for you. I am printed it with ABS and heated the link between the cap and holder ring, to fold it together, but PETG works also I think.…
TPU stabilizer silentblock for Nissan 200sx S13. 100% infill 6 perimeters wall
Profesional scanned high resolution nissan 200sx s13/ 180sx Rear end interior. Category: Automotive
Professional 3d high resolution Scanned Nissan 200sx s13/ 180sx Engine Bay Category: Automotive
TPU silentblock for stabilizer bars. 100% infill 6 perimeters walls
The lower sleeve which is attached to the ignition lock with two screws.
Gasket under the throttle and on the other side of the intake Engine: CA18DET Printed with FLEXfilament
thermostat gasket Engine: CA18DET Printed with FLEX filament
This is an Atoto S8 radio bezel I designed for a Nisan B14 to fill the gaps in the dash around the unit. It will fit a Atoto S8 Standard 7" radio in the factory center console of a Nissan B14 200SX/Sentra chassis, year 1995-1999. However…
a small clip into the electrical connector so that it can be attached with cable ties
Printed with FLEX filament
Positive batery box for Nissan 200 sx s13. When i relocate battery to trunk i needed little box for the cable. At one side is M8 screw and going through fender. and on the other side is M6 screw. All screw been install with little bit of…
This little modification is needed for aspirator hose connect to your heater box to proper work of interior temp sensor. This is the scond version. I am designed only the bottom part of adapter. So you need the JDM part and cut down like…
I didn’t have a button on the center console next to the steering wheel, and I didn’t actually need a functional button — I just needed something to cover the opening. So I made a button that fits Plug & Play into the original spot. It…
Replaces center air vents for 3x 52mm gauges. reccomended to block AC hoses for center panel.
a radiator support bracket, fits Nissan S13 / 180SX / 200SX / 240SX probably also other 90s Nissans
