Counting matching models…
This bracket is made for 10" racks. They have the standard dimensions of 1U (44.5mm) in height and 250mm in width. With these dimensions the mount can be printed on a print bed with the dimensions of 220mm x 220mm. The mount is designed…
It design not to be a tight fit (to prevent scratching), If you want more secure you can insert pieces of paper between shelve or use m3 screw on pre drill hole on top or below My print settings layer height: 0.2 wall: 3 infill: 15% If…
Based on the very good model of ER605 & OC200 Rack Adapters (V2) by Sorcier, I remodelled them to fit 2x TL-SG2210P. It's a heavy device, and 2 of them in this pair of brackets are recommended to be supported, either by support angles or…
I couldn't find a 10" rack mount for a SG2210P which was designed for the ports facing forward. This model has a gate at the back (press in using the bar closest to the "teeth") to stop the switch sliding rearward when you plug in network…
Gridfinity 6x3x4. All my SomeLine cases are 6x3 for uniformity.
This is a 1x6x6U Gridfinity holder for the Someline 2210P crimping pliers for red / blue / yellow electrical connectors (eg. butt, spade, ring, etc..); includes a slot to keep the little manual / guide, if you wish to keep it with the…
It design not to be a tight fit (to prevent scratching), If you want more secure you can insert pieces of paper between shelve or use m3 screw on pre drill hole on top or below My print settings layer height: 0.2 wall: 3 infill: 15% If…
I couldn't find a 10" rack mount for a SG2210P which was designed for the ports facing forward. This model has a gate at the back (press in using the bar closest to the "teeth") to stop the switch sliding rearward when you plug in network…
This is a 1x6x6U Gridfinity holder for the Someline 2210P crimping pliers for red / blue / yellow electrical connectors (eg. butt, spade, ring, etc..); includes a slot to keep the little manual / guide, if you wish to keep it with the…
