Counting matching models…
To replace a broken washer fluid reservoir cap for a OPEL Astra J OPC and some other OPEL models ;-) Original Part No. 13227300 Just printed in PETG orange / black. To hold the cap down i insert two magnets (4,5mm x 1,5mm x 9,5mm). MMU…
There are many similar brackets around for many different radios but none for the Icom IC-2730 , so I made one. I used cheap M4x8 socket head screw from a kit, they worked nicely but I feel that they are just a bit smaller than the holes…
To replace a broken washer fluid reservoir cap for a OPEL Astra J OPC and some other OPEL models ;-) Original Part No. 13227300 Printed in PETG The frame STL is identical to the original, only the lid has modifications.
This model is compatible with the lego system.
This model is compatible with the lego system.
Subaru Overhead Ham Radio Mount (Icom 2730A) Vehicles It Fits: Outback 2015-2017 Possibly 2018 and 2019 as well. Forester: 2014-2016 WARNING: I am not responsible for any damage to your vehicle. This project will permanently alter your…
I purchased a new mount for the control head of my Icom IC-2730A amateur radio. The mount uses the standard AMPS profile mounting pattern, but the radio has a custom spaced mounting pattern. The adapter plate sold by Icom was 40 bucks so…
Jeep XJ 96 and older, blocks off the existing center air vent on the dash.
Got a Mac Mini M4 and a BenQ 27 inch 5k monitor (PD2730S)? Then this is the mount for you :) Attaches the Mac Mini M4 to the back of the monitor to hide the Mac and its cables away, for a clean desktop experience. Printing instructions:…
I designed a mount for the Icom iC-2730A because the manufacturer no longer supplies it with the radio, only as an accessory. I printed it on 3-wall PETG with 15% infill. I hope it's useful.
Because of the complexity of the part I have printed the lever on my resin printer.
I needed a back plate to mount my Icom IC-2730a to a Lido AMPs mount. The stock brackets seem exorbitantly high priced for what they are, so I decided to make my own. Just pay attention that the Lido mount is asymmetric, note the way the…
Zoe Phase 2 (from 2019 on) holder for ICOM IC-2730 print in PETG.
This mount should fit 2002-2007 classic Chevy trucks in the center console between the two power outputs. You will need to drill a single hole in the back for the wire to pass through and I used VHB tape to stick it down to the bottom.
I needed a back plate to mount my Icom IC-2730a to a Lido AMPs mount. The stock brackets seem exorbitantly high priced for what they are, so I decided to make my own. Just pay attention that the Lido mount is asymmetric, note the way the…
![Lego Compatible (2730.dat) Technic Brick 1 x 10 [9 Pin Holes]](https://media.printables.com/media/prints/70a4bad0-83dd-4395-8b56-33cf2e95f7d7/images/10107256_4427ca80-4baa-489f-9d3a-0d9fdeba896b_a5edeb78-0ede-4096-aaed-64b2d635f881/250x250p-4.jpg)
