Counting matching models…
Mobile Phone holder for Gen1 Chrysler 300C, Made to fit in the pocket in the console ,sits along side the shifter with room to access all the control for heater etc.Also the charging cable can be pluged in while in the stand, I used PETG…
Hugo Chávez - Chrysler 300C
If the standoffs securing the display housing on your PowerBook Duo 2300c have finally crumbled, these replacements should get you sorted. You'll need to snip away what's left of the original ones, and keep the brass inserts. Sand down…
Printed out of FilaFlex40, 100% Infill. When I was checking the vent line for the fuel tank on my W123 I noticed that mice had chewed away a good amount of the flexible bell that points downward to prevent debris from entering the vent…
It happened in my 2007 Chrysler 300C Touring. Some heavy load moved and crushed the plastic handle mounted in trunk floor mat. If that happened also to you, may find this model allows to recreate the broken part :) Print instructions…
https://cad.onshape.com/documents/35b39d8c8107c2b331d2780e/w/256abfa0e0ee655659f38151/e/91e73e25f4508157b69f15c5?renderMode=0&uiState=6a8b2185bd0b2e6c57989a03
Bought some Yeelight Smart Ceiling lights and needed space to fit WAGOs to replace the previous wiring of the old light. Original made in OnShape part available at…
This is the rear modem port cover (left side as viewed from the back) for a PowerBook Duo 2300c. This does not include the center screw cover. Print with rafts and 100% infill. You'll also need to use supports. Alternatively, to prevent…
print settings used: 0.4 mm nozzle PETG 0.2 mm layer height 2 wall loops 15% gyroid infill normal snug orcaslicer supports needs to be pushed with some strength but it fits well
Designed in Fusion 360 using the Gridfinity plugin. Based on Gridfinity by Zack Freedman (CC BY-SA 4.0).
Please like before downloading the model . Thank you so much for your support ✌ 3 stl. keychain car siluet
Print Settings: Primeters 4, 20% infill Material: PETG The Inserts on these models are rotated to match a improperly installed like mine seen in the photos, Use some bolts, nuts, and washers you have lying around to attach the shark wall…
This is a lid that goes on top of @Scott711_1627196's print-in-place soft tape measure spool for 120"/300cm soft tape measures. The original model has a hole already. This screws into that with an M3x4 flat head screw. The screw threads…
