Counting matching models…
This is a wall mount for Guition ESP32-S3-4848S040 ESP32-S3 based touch screen, which can be purchased without the relay base. The relay base doesn't fit in a standard 60mm diameter appliance wall box, so if one doesn't really need the…
Version 2 update: Version 2 of the frame has some notches to click the frame into the rear section. This is a snug fit that snaps into place and is difficult to remove it again but will pull apart without damaging. Version 2 of the…
I've been using jtenniswood's project for making easy LCD control panels (https://jtenniswood.github.io/espcontrol/).
This is a simple casing for the Guiton 4” 480x480 ESP32-S3-4848S040 Smart Display. The display fits just right with additional space at the back to place battery. The USB C connector is still reachable for easy charging.
The case consists of two parts, which are attached to each other using 8 magnets 6x3mm. The adapter can be used as a standalone case for mounting the display on a metal surface. No support is required when printing.
ESP32-4848S040 LVGL display wall mount dose. No holes, drill them where you need them after print. For two screws use heat inserts.
Mount with a recessed pocket for the screen, no fragile plastic clips, for surface-mount installation onto a standard 60 mm flush-mounting box. Oblong holes allow horizontal alignment adjustment (tested with Legrand flush-mounting boxes).…
Case stand for the 4inch 4848S040 ESP32 Touch Screen Printed @ 0.24 layer height in PLA - no supports
Mount with a recessed pocket for the screen, no fragile plastic clips, for surface-mount installation for an outdoor Schneider Mureva fixing frame. This is a test as I'm not sure how the Guition display can handle the outdoor conditions…
A simple remix that adds USBC/PD module support.
This is a simple casing for the Guiton 4” 480x480 ESP32-S3-4848S040 Smart Display. The display fits just right with additional space at the back to place battery. The USB C connector is still reachable for easy charging.
It is necessary to remove the back cover and replace it with the printed model. PET_G. 0.16
