Counting matching models…
Ersatz Gummipuffer Heckklappe am Megane 2 Coupe Cabriolet. Da dieses seid Jahren schon nicht mehr bei Renault verfügbar ist, habe ich selber einen Designend. Die Montage ist etwas unentspannt, da die Aufnahme sehr eng ist. Mit etwas…
Shimano Rear Derailleur Pulley For bearing 689ZZ (17x9x5 mm) This model is suitable for upper and bottom roller. Print Settings Printer Brand: Creality Printer: Ender 3 Rafts: No Supports: Yes Resolution: 0.2 Infill: 50% Filament: eSUN…
This model is compatible with the lego system.
I bought MAIWO K1689 M.2 NVME/SSD Neclosure to USB-C to be able to connect a NVME board via USB interface. Then I promptly lost a silicone plug it came with it. This is the replacement. This plug will also fit any mount hole that is 4.5mm…
This model is compatible with the lego system.
These switch covers for the Mercedes Sprinter W903 offer a snug, secure fit—requires firm pressure to install properly. Printed in ABS-GF with 3 walls, 15% gyroid infill. Supports optional, but recommended for best results. Available in 3…
LEGO Compatible - 56891-Tire 37 x 18R
Replacement of boot curtain clip for Touareg 7P OE No 7P689877345
After replacing the battery twice and screen once on my Nuvi 2689 due to the car being in the sun and getting very hot due to direct sunlight. I designed a sun shade to try and protect it. 2 years later it seems to keep the unit cooler…
Prints in two pieces. The lower piece can be held in with a zip tie, and has room to use the original velcro strap to connect the battery. Designed for a 75mmx34mm battery (2200mAh 2S), but can hold up to 88mm and maybe more with some…
As the Hailo trashbin didn't offer Lids, i created one by myself. This is useful, for instance if you store organic waste in your trashbin. It is compatible with those 7 Liter compartements: Articlenumbers: 1082479 and 1068909 Those bins…
Remixed Rear Wing by StreelyDan for the Haiboxing 16890a to have appropriate geometry for attaching this wing to the Haiboxing 16890a chassis.
Similar to my other model, I created a dust cover for the HBX 16890 to protect it from coarse dirt. Since I don’t know how the motor’s heat dissipation will perform over time, this may not be the final version. You will need an M4x16 or…
Hi. I've designed a holder for my newly bought Werckmann utility knife. You can find this knife in Action store or buy it online. The holster was designed to hold the knife quite tight. It won't fall off even if flipped upside down. I've…
## Moulinex Cookeo Ball Support / Holder – SS-996897 Replacement This is a 3D printable replacement for the ball support / ball holder used in Moulinex Cookeo pressure cookers . I designed this part as a replacement for the original…
This model is compatible with the lego system.
Remixed Rear Wing by StreelyDan for the Haiboxing 16890a to have appropriate geometry for attaching this wing to the Haiboxing 16890a chassis.
This model is compatible with the lego system.
