Counting matching models…
UPDATE: The "remix_drip_bracket_7.2" version (shown in blue) fits better and centers the build plate over the resin vat better. I will remove the earlier version to prevent any issue of downloading the wrong file (earlier version shown in…
12/8/2023 - Added a version without the loop on top of the handle. I remixed this handle to fit my Anycubic Photon Mono X 6Ks, by adding a hanging loop. I also fixed the screw holes by adding more material under the screw heads. I also…
Print approx. €4.68–€5.72 excl. taxPreliminary estimate for one variant
Just a basic drip hook for Anycubic Photon Mono X2 (remixed from Mono 4K Drip Hook)
| BASIC DESCRIPTION | an adapter for anycubic phton X6Ks used for faster dripping of resin back into the vat | DESIGN DECISIONS | it is tilted in two axis so that the rasin drips faster it is designed to fit in place of the plate and can…
simple as, im using ASA but PLA will do just fine. Have fun. https://cults3d.com/en/3d-model/tool/anycubic-photon-mono-x-6ks-drain-dripper-plate-holder-anycubic Category: 3D Printer Accessories
I had some aluminum poles (2 of 200.30 mm and 2 of 100.40) so I made another stand for the vat holder that samuelemarazzita made. I modify the holder of the vat so the poles fit, the rest its my design, 2 M4 screws made the funnel base…
Some simple TPU vibration dampening feet to fit the Anycubic Photon Mono X 6Ks. The resin printer has hard plastic on the base, these fit over those extrusions to act as vibration damping feet. Printed at 4 walls, 1.6mm top & bottom, 20%…
Cestovní sada štamprlí s pouzdrem 6ks štamprlí o objemu 2cl (po vrchní okraj 2,14cl) s pouzdrem, které má víčko. Co k tomu dodat. Skladná, lehká a praktická sada k posezení nebo jen tak na stojáka s přáteli na výletě nebo doma. Pouzdro…
Print this wedge 8-10x times, depending if you have a heavily warped upper case: put vat on glue 8-10x wedges around and wait sufficiently before putting cover over My Mono X 6Ks came with heavily warped upper case, and it didn't fit at…
A bracket to fit on the Anycubic Mono 6Ks resin printer to hold the build plate at a 40° angle to all excess resin to run-off back into the vat. The bracket is designed to fit onto the Z-arm just behind where the build plate fits and…
Just print the Stand for the RC-Model of the Mercedes G 500 4x4² by MN-Models. Perhaps you need to glue the feet of the holder, but ist very useful to keep or repair your model. It works also with other MN-Model that use the same chassis.
lock Abus 4960 NR+ Chain 6KS/85 rear rack model is: Ibera PakRak Touring Carrier Plus+ IB-RA5 M4 bolts
I was annoyed by the fact that all drip brackets out there required the bracket to be taken off while printing. So I des
