Counting matching models…
A hydraulic piston looking abdomen armor for Dummy 13. This is a hard print, it'll probably not work on 100%-150% builds, and will need supports. The looks are worth it, though.
Based on DUMMY 13 Beta - Oct. 2023 DUMMY 13 Printable Jointed Figure © 2023 by Lucky 13 Toys is licensed under CC BY 4.0 Get your Dummy 13 here: /model/593185 I designed this parts to create different costumes for DUMMY 13. The parts can…
This model is a remix of the original model! It should be fine for printing at 100% but i am not sure about any other sizes!
I left part of the abdomen deeper so that the fit with the fram would be better
A 3D puzzle of the lower abdomen, teaches learners about the placement of the organs and their relative orientation and size. Some of the models needs support: Support on buildplate only! (use “snug” option if possible) Top 2 layers on…
Photos coming soon, but it's tested to work! Assembles exactly like the original, just without the gluing Of course, the looks are slightly compromised, but prices must be paid for supportless models.
Green armors: thigh, upper arm. Other armor are Black.
UPDATED 26-JAN-2024 The only change was to scale the STL file from CM to MM.
- Stretch for better fit of the frame abdomen V6
new dummy 13 Torso and abdomen for Cyborg, advise print the dummy at 150%. As it is ready I will ad an photo
This is TWO! New arts to add to the robot: the abdomen and crotch, and then I will work on the head next, so hope you download the chest piece so you can add these on there :)
After upscaling the Dummy 13 v1 @ 150%, I could not get the crotch to snap into the waist nor the abdomen into the chest. I tried scaling the piece and adjusting the flow. Neither of these slicer changes seemed to help. So, I simply…
The original abdomen frame piece was too short to reach the chest piece for me so I extended it a bit to allow for the pieces to join properly.
