Counting matching models…
This is a little thingme I thought would look really cool on my blasters, not to mention having 20 extra darts handy. Supports will be needed. I used PLA filament for this. Just a note: you will probably need to turn this diagonally on…
Absolutely minimal (Deco-) egg-stand. Prints in lesss than 10 minutes and does the job...
Holds my 3s 2ah bricks with a bit of room to spare, hold lid closed with a super long m4 bolt (at least 65mm) and nut, ziptie to your handguard or something idk. Print with the solid end of the box on the bed, and the top of the lid on…
This Classic Door Handle is what you need for proper operation of your new Kobra S1. Just unscrew the old one and burn it, it's boring anyway! -Original screws fit. Pros and cons: +It's mandatory +opens the front door +less than 7g of…
The main reason why I made these plates was to learn FreeCAD - I wanted to learn and make something useful at the same time! These plates compatible with: * Fast-Operation Vise by…
This is a little thingme I thought would look really cool on my blasters, not to mention having 20 extra darts handy. Supports will be needed. I used PLA filament for this. Just a note: you will probably need to turn this diagonally on…
Absolutely minimal (Deco-) egg-stand. Prints in lesss than 10 minutes and does the job...
Print-flat chain mail. 3-in-1, so it had to do an over-under wobble pattern to lay flat on the sheet. Absolutely infuriating to play with - it binds up, it tangles, it refuses to lay flat. The opposite of a good fidget toy.
The attached file is set up as a color print. The file can be modified to print on an MMU by adjusting the heights of the objects in the file. The attached picture shows the model printed on an MMU. The rubber duck was remixed from…
Absolutely the Best Zte Brother Tape Holder. Some research and tests went into developing gripping profile for tapes, and proper ratio of spacers to grippers so it holds 6,12,18,24mm tapes identically. Can be scaled vertically and…
I had a lot of problems with filament being stuck due to the higher friction of pulling out of the Ikea 365+ container and through 1.5m of reverse bowden. I liked the version created by AlexMu but there were things that I thought could be…
