13 models
50 mm diameter and 63 mm height for 1kg standard spool or for your sock drawer ! I created it basically to store my filament spools in the best way. I place the container inside spools to save space because I store my spools in waterproof…
I made this project beacuse there weren't cases enough ventilated for Raspberry Pi Zero and Pi Zero 2. I made this simple and compact design. BOM 4x M2x10 screws
I liked the design so I drew this plug up for fun. I have mounted a small cabinet with two of these. However, they are not certified and I can't take any responsibility for using these. Use them at your own discretion. Brim included in…
This is an aerated planter for orchids. Print all three parts. The middle part should be printed translucent since the roots need light. Assembly The bottom part and middle part are clamped together. Pin a thick cord in the middle of the…
This is an excellent orchid pot. I found that the top rim of the original design was a bit too fiddly to install, so I simplified it. Kudos for chrido for an excellent design. Print instructions Use the original base, center and…
BOM: Printed with ROSA3D Starter PLA Black Keep your sink area clean and extend the life of your sponges with this cleverly designed, self-draining holder. No more soggy, smelly sponges sitting in a puddle of water! Key Features: Elevated…
I was looking for a pot to split and replant my monstera and there are lots of decorative plant pots to choose from but not a planter that would make sure my plants will stay hydrated and get some air going through the soil. I feel like…
I really like the design of the original container, but whenever I try to fill them my balls spill and it's not easy to find these little buggers. I had an epiphany that I have a 3D printer for solving exactly this type of problems :) I…
I carry a sponge (cut in half) and small bottle of dish soap with me in my lunch bag to wash my dishes with after lunch at work. I needed a small box to carry the sponge in that was well-ventilated enough to allow it to dry without…
i wanted a short tab stand for my umikot but i wanted it to be aerated as to discourage bacteria growth and use less filament
In the cardboard core spools I use (similar to Bambu's) the original was too short and could easily sit crooked. This is the small mesh / thin version. Also check out my funnel remix to easily fill these containers:…
i printed this with PLA and cut it just below the top rim for easier/faster slicing. If you do not cut it, you will need to enable supports
Stacking bottle dryer that should not retain water
