Counting matching models…
Design inspired by original Tailfin light mount and using the same 2 screws to mount. So you may reference the original installation manual. Reinforced the structure and straightened the mount for extra durability. Adding the second mount…
Obviously not made by or associated to tailfin! The newish (2024?) Aeropak has different screws on the bottom than older models therefore the existing stls didn't fit. Had to make my own one. Using existing screws, just added Loctite to…
light mount with 25.4mm diameter. You can use the existing screws.
Lighting mount for a tailfin cycling rack. Design is fully parametric, so the angle, height and diameter of the cylinder can be customised, just ask. Designed to be printed with a high perimeter wall count and very low infill volume…
Received my Tailfin Aeropack today and figured out that the seatpost clamp was too close to the saddle in order to open the bag. Made an adaptor quickly which solves the issue. Category: Sport & Outdoors
A Garmin mount for Tailfin top bags. Compatible with newer top bags (AeroPack / AP18) where the distance between the accessory screwholes is 64mm (standard bottle cage spacing). This will not fit older Tailfin models where the distance of…
38mm Motor Retainer This is a screw-style retainer for 38mm high power rocket motors, inspired by similar retainers from AeroPack and Apogee. It securely holds a 38mm rocket motor in the mount so that it is not popped out by the rocket's…
This mount allows for the use of GoPro-style accessories on the back of the Tailfin AeroPack. The bolt holes are spaced to fit the "Light Mount (Fixed)" accessory by Tailfin. Two M5 x 12mm bolts, two M5 washers, and three M5 nuts are…
When I use the Aeropack, I can’t connect the Varia to the seatpost. So, I came up with a design that lets me attach it to the Aeropack. Simply mount your Varia on the VariaMount and tighten it up. Used Materials VariaMount: PETG, supports…
Just one of the ways to mount a reflector on your bike
Adapter to mount a rear bike light (having a Bontrager style mount) to a Tailfin AeroPack. Create the best fit by heating and bending the adapter a little. Take the existing rubber from the Bontrager rear light (saddle post mount) and use…
Adapter and spacer to use 38mm motor in 54mm retainer and 29mm motor in 38mm retainer. I recommend printing with a higher temp filament, e.g. PETG, ABS, PCTG, etc.
I built it for my Garmin Varia. Used Garmin socket from another mount which I had lying about. I'll probably create a version which doesn't require that. Features minimalistic look fits Tailfin bags with holes 64mm apart light doesn't…
