Counting matching models…
Camera mount - print in PETG. Antenna mount - print in hard TPU (70 D or harder) and use cable ties to fix antennas in place. Supported camera ange is from 0 to 30 degress (the mount is slightly in frame at 0 degrees). When printing…
Support pour Airunit DJI O3 Il vous faudra 4 ecrous M2
Une version 4" Unibody ou bras séparés du JeNo 3"/3.5" Toutes les pièces du JeNo 3"/3.5" et 4" sont inter compatibles version : Unibody Bras séparés électronique : Aio 25.5x25.5 ou Stack 20x20 Aio 25.5x25.5 Épaisseur carbone bottom plate…
Original GEPRC MK4 HD5/HD6/HD7 DJI FPV Antenna and Airunit Mounts All copyright goes to GEPRC who kindly shared these files.
Custom DJI antenna mount with XT60 and capacitor mount for the GepRC Mark 5 Custom DJI AirUnit tray Matek Voltage Spikes Filter XT60-TVS https://buzzfpv.com.au/product/matek-voltage-spikes-filter-xt60-tvs-pack-of-5/ Category: R/C Vehicles
Custom DJI antenna mount with XT60 and capacitor mount for the GepRC Mark 5 Custom DJI AirUnit tray Matek Voltage Spikes Filter XT60-TVS https://buzzfpv.com.au/product/matek-voltage-spikes-filter-xt60-tvs-pack-of-5/ Category: R/C Vehicles
For my setup, the mounting holes for the DJI O3 AirUnit at the back of the Rotoroma Buddy frame were too far to the back, so that my camera cable was not long enough. I am flying the Rotoroma Buddy 5" Deadcat , but my model should work…
MoonGoat Air unit cage with integrated xt60 GPS and antenna mounts. Designed to be printed in TPU. Might need another version that raises the height of the air unit antenna's.
The DJI O4 Air Unit is a perfect video transmission and recording solution for small copters, such as whoops. But it can take up to 9W power which leads to overheating if there is no quite strong air flow around. So it is not possible to…
Model printed with PLA Mount: 15% Infill holder: 80% Infill
I love to make useful 3D Desgins, and i love Coffee: Buy me a Coffee: https://www.buymeacoffee.com/phitscho Or Twint me something over 078 713 68 61 THANKS! DJI Airunit Camcablenut Holds the cable in place It is needed if you wanna…
Rear Bumper and DJI stock antenna guide for Hyperlow-Airshot frame Used with this AirUnit mount: https://www.thingiverse.com/thing:4623368 Bumper protects DJI AirUnit Wires and guides antennas down and out, I needed this as I have a…
A bracket that mounts on top of the Edge Smart Drive T3 Airunit to hold additional hardware. Features: Supports 20x20mm and 16x16mm M2 mounting patterns Includes holes for cable ties Hardware: 2x M2x3 screws Support my work: All of my…
