Counting matching models…
Version 2 of the Airwolf model. This model is based on the basic design by Hans Meyer at Grabcad, remixed, STL's fixed, updated, missing parts added. The front fuselage needs to be printed heavier (30% infill) as opposed to the rear parts…
⚙ RECOMMENDED 3D PRINT SETTINGS Material: PLA or PLA+ recommended Layer Height: 0.16 mm for finer detail; 0.20 mm for faster prints Infill: 10–15% recommended for most models Wall Loops: 2–3 Supports: Enable where necessary based on model…
Airwolf Film / Cinema room sign, Colours can be altered to whatever you prefer through your AMS (Bambu) or through you current printers configuration. Large Measurements approx.: 22cm x 7.5cm x 2cm Medium Measurements approx.: 17.5cm x…
Airwolf - Stringfellow Huckleberry - 1984-1986 3D printable model.
Airwolf - Dominic Santini - 1984-1986 3D printable model.
I finally managed to generate a model from an image that looked like i could work with it. However i am not an experienced modeler. Im gonna try and finish it, but dont expect anything fast. So anyone who wanna have a go at it, please do.…
Airwolf - Michael Archangel Coldsmith-Briggs III - 1984-1986 3D printable model.
Use case, I was asked to create a toy helicopter that could carry a net to be used in toy dinosaur rescues. I couldn’t find a suitable model so I used Ai tools to quickly make a model and modify it to fit. Elapsed design time 45 minutes…
Parts needed to ditch the bowden, and use a J-Head! You will need to use extra washers and things to get the spacing right but it works well. I did use a greg's wade parts from somewhere, so If you recognize your parts let me know and I…
This is a model of the Airwolf Axiom 3D printer Print Settings Printer Brand: LulzBot Printer: TAZ 5 Supports: Yes Notes: Rotate model 90 degrees on the X axis to minimoze supports Category: 3D Printers
I could not resist buying this little GPS-stabilised Airwolf on a local exhibition. The Airwolf is offered with different brands, e.g. Eachine E188S, FliteZone and many others. As I am normally flying FPV copters I wanted to add FPV…
Opener for AirWolf soap and paper towel dispensers and hand dryers.
Obudowa do Daystate, w przypadku przeróbki kolby na własne mocowanie i zasilanie z 2x18650 lub 14500. Materiał: ASA, ABS lub PETG Infil: min. 40% Podpory: Tak, organictree
Holds 5 inch dia. spool with .75 inch dia. hole, such as Taulman 1 pound. Replaces holders that ship with printer. Uses factory hardware for mounting. Instructions Designed to be printed at 100% infill without supports. I used ABS, PLA…
STL sliced in Ultimaker Cura 4.12.0 for printing with PLA on the Anycubic Mega S with the following settings: Draft - 0.3mm Generate Support Support Structure: Tree Support Placement: Everywhere Support Overhang Angle: 33.0 Support…
