8 models
The lower part of the ratchet mechanism cracked preventing the clamp from working. The modelled part follows the same design as the original with a few improvements: • Added chamfers to help spread the load • Walls made wider where the…
Case for pinecil solder, 7 tips, three reels, amtech flux and piston, sucker, two compartments with lid and one big
Case for pinecil solder, 7 tips, three reels, amtech flux and piston, sucker, two compartments with lid and one big
I didn't have the original Delta PSU components to use and I try not to open power supplies, so a replacemnt 5USD AdamTech inlet is a economical choice. Note that the original model is marked Mk3, but I'm pretty sure it is derived from…
As original Tamtech batteries are very old and not reliable any more, I have designed an adapter so that you can fit modern LIPO batteries. It is designed for small LIPO batteries like THIS ONE . Two versions, depending where you prefer…
As I want to run my Tamtech 1/24th Ferrari Testarossa, I have removed all the stock electronics and am replacing them with updated kit. The servo I chose to replace the stock version from the '80's was a Turnigy MG90S - cheap, easily…
As I want to run my Tamtech 1/24th Ferrari Testarossa, I have removed all the stock electronics and am replacing them with updated kit. This sled will fit the Turnigy Nano-Tech 450mAh 2S LiPo (and smaller) batteries - there's a bit of…
A case for SLAMTech's RPLidar 360 (A1) that protects the lidar and has room for a raspberry pi zero w. Surprisingly the pi zero w has enough horsepower to process up to 10hz from the lidar while also running hector_slam, telemetry, and a…
