Counting matching models…
This model is designed to be used to create cutouts or mounting points for the 8 digit 7 segment max9219 display circuit board. Included is the STL file and also the openSCAD source file so you can use it in your own openSCAD projects too.
I highly recommend printing in PETG or relative strength material and to orientate the model 90deg sideways to best use advantage of the layer line strength for the clips. I made the model fit quite snugly to keep good hold of the helmet…
The mount is attached using 3M VHB, which removes all of the gaps. My printer is not dialed in well, so it does not look great. I print it verticaly, you will have to cut a little off of the bottom to get a good first layer contact area.…
Printed with PETG and 100% infill.
An enclosure for Adafruit Stereo 3.7W Class D Audio Amplifier MAX98306 . Currently this enclosure is for direct soldering scenario only, i.e. you cannot use the enclosed screw terminals and the jumper. Cable holes are designed for raw 22…
I made this model to be able to mount my Xiaomi AX9000 router on the ceiling. 4 brackets are required. Drill the ceiling with 300mm x 70mm rectangular template. Install the brackets but do not fully tighten the screws, leaving the…
Created for use with the DJBB Maggie antenna . This is an enclosure for the Adafruit MAX98306 stereo amplifier module. It has aux in and aux out. I chose to power it with a powerbank via a USB cable, but you could use whatever as long as…
Seeed Studio ESP32C6 + HiLetgo MAX98357 + CQRobot Speaker Case Dimensions: Speaker - https://mans.io/item/cqrobot/cqrlb4o3w-b Amplifier - https://www.adafruit.com/product/3006 ESP32C6 - https://www.espboards.dev/esp32/xiao-esp32c6/ No…
It's just a simple case, it should print easily in any material you like. No supports needed. I used a brim but that's just because I'm printing with ABS and it doesn't like sticking to my build plate. The lid is a tight squeeze over the…
I highly recommend printing in PETG or relative strength material and to orientate the model 90deg sideways to best use advantage of the layer line strength for the clips. I made the model fit quite snugly to keep good hold of the helmet…
