5 models
Printed using a tree support. Wiring was done as follows. Cut the red line from the 4pin cable and connect it to the COM and N.C of the limit switch respectively. The AMS will switch off automatically when you insert external filament.…
This is a rear camera for the Raspberry PI 5MP Board that mounts at the rear of the Bambu Labs X1/X1C/P1P in the 2 centre holes.
Complete redesign of the original idea: OpenScad-File Lid is removable without breaking the pins holding the camera Camera is shifted to the left and now centered within the enclosure (the two holes aren't centered. Tested with Raspberry…
Remixed this to add the outside spools to allow it to work in a Bambu AMS unit even if it is a cardboard spool or smaller.
Print as you normally would. I'd suggest something with some temp resistance so no PLA.
