Counting matching models…
This design is optimized for print speed without any disadvantages over the original RC3. Other remixes similar to this I've tried have an issue where the thickness of the walls is just enough to leave a small gap and easily snaps apart…
After delivering 50 RC3s to a local hospital I worked with them to further improve the design to address their concerns. With the RC3 they liked the comfort and its the ability to adjust to any head size but disliked the open top and…
I could not find while searching wide and deep anyone who provided the “plain” adapters for my good old DC24 DYSON so i remixed them for everyone, now you can further remix anything you need and i personally am going to build a few Dyson…
I bought this 5-in-1 saw at Praxis and found that i tended to avoid using it as i was too impatient to change the saw blades. Designed this handle so i could give a individual handle to each so they were ready when i needed them. It fits…
What Is It? The BaselineDesign Mask was developed to solve the many design flaws of a 3D printed mask while remaining just as easy and accessible to make. The design uses readily available two-part silicone poured into a simple 3D printed…
The holder fits the extension cord: "base line V-02" which you can buy in Praxis Netherlands called: "Baseline stekkerdoos 5-voudig zwart" but I think that should also fit other Baseline extension cord products. I designed this so that…
This model serves as a baseline for creating your own filament runout sensor. Model uses: Endstop with lever 2mm self tapping screw holes for securing endstop (or use 1.75mm filament to secure it) 6 mm PTFE Tube (4mm OD) instead of steel…
Inspired by and reversed engineered from Isaiah's Friendly Articulated Slug, these are base articulated joints that can be used to to build articulated models off of. I have included the original solid model files as well as generic…
Well, check your baseline. This will hold a Pi Zero and Pi camera with wide angle lens. More reference on https://www.therpf.com/ . Work in progress but this has a lot of space for additional circuits. Orient the pieces so that they print…
I designed this in SolidWorks to replace a missing Yakima Rack foot. it works perfectly. photos show original next to 3d print
https://baseline.markets/ Print as shown in the images, requires supports. Do a pause near the logo to change colors to make the logo stand out!
