Counting matching models…
Adapt .25 OD plastic pneumatic/icemaker tubing to PC4-01 BSPT Thread. Works with Sunlu FilaDryer Filament Dryer S2 PTFE Adapter by MichaelQ Update: Works best using PTFE bowden tube as a liner inside the length of your nylon tube.
Print approx. €0.32–€0.39 excl. taxPreliminary estimate for one variant
Note BSPT thread, used commonly in Europe. I'd recommend printing with the thread up, to avoid printing horizontally in thin air. Printing like this, use a small brim to increase print stability, no support needed.
2 inch / 50mm male to male pipe nipple to connect pool-pump pipes to pool inlet and outlets. Part of the profile is Hexagonal to assist with tightening using suitable hand tools. Used PETG and I found minimum 3 wall and 30% infill strong…
I created this adapter / reducer to connect pool-pump pipes to pool inlet and outlets. Part of the profile is Hexagonal to assist with tightening using suitable hand tools. Used PETG and I found minimum 3 wall and 30% infill strong enough…
Using to mount a 14" PT pneumatic fitting to a 1½" UNC cap.
Hose barb to for a 10 mm ID hose to a ¼" PT (JIS) or BSTP pneumatic air connector fitting.
Check the thread before ordering your pool lights Not sure whether your pool fitting uses BSP or NPT threads? This set contains three externally threaded samples for comparing the fit in an internally threaded, nominal 1½-inch pool…
