Counting matching models…
This is a very specific part for my custom motorcycle, but who knows maybe it could be useful to someone else. This should fit a Honda CB550 fitted with a Cognito Moto 38T front sprocket that has the 3/8" offset for installing a wider…
This a speedo mount to fit on a an R6 Forks. I believe this would fit on a R1 and similar years too. The boss for the ignition key has been cut off to fit this. This fits a 85mm or 3 3/8" Gauge, the one I specifically have is a “Motor…
This is a throttle tube designed for some mukini carbs on a 76 honda cb550. I printed this out of nylon carbon fiber 100% infill on a x1 carbon. It is used to replace the 2 cable system to a single cable system that the Mikuni carbs use.
I have a 1974 Honda CB550 - I don't like the ignition switch located at the side under the gas tank. I prefer having the ignition switch between the speedo and tach like later years. Unfortunately, it is a major parts swap to go to the…
The indicator lamp boots are difficult to find without being attached to an expensive wiring harness. This mold allows you to make the boots out of high temperature Permatex RTV silicone. The 3d printed test part is in silver blue and the…
This is a throttle tube designed for some mukini carbs on a 76 honda cb550. I printed this out of nylon carbon fiber 100% infill on a x1 carbon. It is used to replace the 2 cable system to a single cable system that the Mikuni carbs use.
