9 models
Three different diameter plugs for the motorcycle frame: 44mm plug (2 needed) 38mm plug 33.5mm plug I printed these in PLA and find they fit my frame holes perfectly. They're sized to press in quite tight to a 10mm depth and have a slight…
These plugs conceal the holes when you remove the rear passenger grab handle. You will probably need some replacement M6 bolts for the front screw holes, as the original ones may not have full thread to screw in far enough. I'm not sure…
When you remove the original rear indicators on a Honda CBR1100XX it leaves a large flat plate with two holes. This adapter covers both holes and lets you mount a round-based aftermarket indicator onto the bike with the wires fed through…
Flat plug to push into a hole in the centre of the yoke. It's normally capped, but I bought my bike with this missing. The previous owner probably mounted a sat-nav here. It's an easy fit, not tight. You might want to allow some…
You need an (OPTIONAL M8 and) M5 Thread drill. You need also (OPTIONAL a M8 30mm screw ,) 4x M5 20mm screws and a 300mm M12 Screw. The M8 Screw is for a better durability.
Its an holder for an USB Charger with an integrated voltmeter and a KCD1 switch (round version). You need two M5x25mm Screws. USB-Charger:…
Its an brake line holder for an Honda CBR1100XX. I upgraded my brake setup to steel flex brake lines and needed an new holder so i created this one. Fits brakelines with an outer diamter of 7mm. Print it with TPU with an infill of 15%.…
Its an brake line holder for an Honda CBR1100XX. I upgraded my brake setup to steel flex brake lines and needed an new holder so i created this one. Fits brakelines with an outer diamter of 7mm. Print it with TPU at an infill of 15%.…
Three different diameter plugs for the motorcycle frame: 44mm plug (2 needed) 38mm plug 33.5mm plug I printed these in PLA and find they fit my frame holes perfectly. They're sized to press in quite tight to a 10mm depth and have a slight…
