Counting matching models…
wanted a tablet at eye level for my 2950 treadmill, so i made one. This clips on to the small gap on the top of the display. Fits a Samsung S7 tab, but should also work with a 10-11" ipad. Hope it works for you! Note you have to print 2…
The Wife needed a place to place her bottles when working out, here is what we designed.
a BACtrack C6 case - remix of https://www.printables.com/model/1358986-bactrack-c8-case
Tired of keeping your phone in your pocket or bag while you workout? No where on the equipment to place your phone? With this holder you can easily attached it to the top of the display with some Velcro.
A phone holder for the S22i bike with the flat tray in between the weight holders. I printed it in PLA with a 15% infill and it felt pretty solid. Place the left side facing down on the build plate so that you wont need to print with…
Just a simple baby monitor mount for the monitor on the Nordictrack bike. Probably could be refined a bit further, but works well enough for me to get me through baby number 2 :) Including the STEP if someone wants to remix.
This is a replacement support bracket for a Nordictrack 2750 Pro. This goes on the support strut to lock the treadmill in the folded condition. Category: Replacement Parts
a BACTrack C8 Case. Enable "Precise Wall" and "Precise Z Height. Inner/Outer/Inner Wall Printing order is recommended.
I created this for my wife's treadmill to hold her Galaxy Tab 10 tablet while she uses her treadmill. Nordictrack sells a molded plastic tablet holder for over $100. After a few hours of design and a night of printing I have a working…
a BACtrack C6 case - remix of https://www.printables.com/model/1358986-bactrack-c8-case
Printed at 100% infill for durability. Postprocessing getting the supports out was a little tough.
The belt tensioner on my wife’s old NordicTrack Elliptical broke and made it almost inoperable and caused a loud knocking noise while exercising. I tried to get a part replacement from the NordicTrack dealer, but unfortunately the model…
Riser holder for little Bluetooth remote i bought on Aliexpress. It can be printed without any supports. Recomanded material is PETG.
My ancient NordicTrack GX4.0 stationary bike was made to hold an iPod (Remember those? Not to be confused with an iPad). Now, I have never actually owned an iPod, but I do have an Android tablet. So I made a tablet holder that fits into…
Cable stop for the resistance control motor on a NordicTrack elliptical machine. The factory one is just a little plastic tab attached to the motor that breaks off and sticks the machine in full resistance. My wife was not happy ;) The…
Holder for NordicTrack EXP 10i or any NordicTrack treadmill with 4 mounting holes. Made 2 versions: one with long and one with short bottom edge so if you have smaller display edge print the small version to not have it interfere. Print 2…
Printed with 15% infill and standard 0.2mm settings. No need for support. Print vertically as shown in the model diagram. You need to push the print in to the back vent of the treadmill and it will hold on to it securely.
