Counting matching models…
Low profile housings for old school DB style connectors, with a variety of holes for cable sizes. They snap together and don't need any nuts or screws. The numbers in the variations are the intended cable diameters, in millimetres.…
I modelled this based off a classic DB15 connector with a few changes to make it easier to print. The tolerances should be compatible with a similar connector (with an adequate 3D printer), as shown in the pictures. Planning on remixing…
The plate should have the correct space around the connector. Because it is drawn with official measurements. Just substract the plate from your object and the connector is integrated in your design. The cut is also intend to be cut of…
2 part cover for 9-pin serial or 15-pin 'VGA' style connectors
Simple DB9, DB15 and DB25 angled style mounting brackets, with 4-40 thread (#4) for standard standoffs (Imperial not Metric). Because of the integrated thread and the open design it is very easy to mount the plug even when the wires are…
The case that is linked in the OnStep project is dead so i just made my own.
This bracket allows for mounting a DB15 (display) connector and MicroSD extender. Designed around this SD extender: https://www.amazon.com/dp/B09CKRDFTH The DB15 connector is more typically mounted behind a metal plate. A washer can be…
This is a dust cover for standard DB 15 ports with screw holes for mounting
This bracket allows for mounting a DB15 (display) connector and MicroSD extender. Designed around this SD extender: https://www.amazon.com/dp/B09CKRDFTH The DB15 connector is more typically mounted behind a metal plate. A washer can be…
The angle adapter was to bulky for me so I've redesign plug. After printing it is a little bit flimsy but if not abused it fulfill the task. Original hardware should be enough to assemble it.
This is a dust cover for standard DB 15 ports with screw holes for mounting
You may want to set your tolerances a little higher than I did on this print, as the clasps that hold the two pieces together can be a little stiff if you don't. You might also want to apply a small dab of superglue to the end of the…
This is a snap case for the USB2DB15 PCB by Raph_friend. There are a few other cases out there, including an official one, which you can find on the USB2DB15 forum thread at…
