Counting matching models…
Based on jtpeyton Digitrax Throttle Dimensions. I needed to change the bottom to allow access to the Loconet Cable port (because I use a tethered system), and the lanyard attachment to fit in the holder for the Digitrax DT600 throttle. It…
I really liked carlpgilbert222's throttle for the Digitrax 400 series throttle that I printed, so I made one for my new UT6 since the other one didn't fit. The bottom is open for the cable. I printed it standing upright and didn't need…
Inevitably the battery cover on your DT400/1/2 throttle will break. You may go insane trying everything from duct to electrical tape to keep the 9v battery contained. But eventually, that battery will simply fall out at the most…
Simple clip to help keep cables aligned in your Digitrax power center. While hold 4 cables, screw in place. Print instructions Unassociated tags: db 220, dcs 240 Category: Electronics
A clip that will slide onto your Digitrax DCS 240 or DB 220 to keep your cables nice and organized. Will hold the three cables coming out the front of your booster. (I'm not sure if it will fit the older Digitrax boosters - I think they…
This box comes in versions with and without ears for mounting to the bottom of your layout. Use M3x6x5 threaded heat insert nuts and M3 screws to hold the board. The holes on the ears are sized to fit #6 pan head wood screws. Also…
