Counting matching models…
Based on jtpeyton Digitrax Throttle Dimensions. I needed to change the bottom to allow access to the Loconet Cable port (because I use a tethered system), and the lanyard attachment to fit in the holder for the Digitrax DT600 throttle. It…
Print approx. €4.07–€4.98 excl. taxPreliminary estimate for one variant
You can mount your licenseplate, turn signals and taillight. Yamaha DT50 2003 - 2011 turn signal- LED, slim ones fits best, M10 Taillight - LED, C-C 60mm Works with standard print settings, increase peramiters at screw holes for sturdier…
HDT5 Timing belt - 11 mm width, 400mm (80 T) length. Printed with TPU Extrudr Flex Hard
It is a rigid box as a case for the DTAPE DT50 laser measurer, it is a tool that travels a lot and is fragile, it is better than the cloth case that comes as a gift. The screws to use are: hinges 2.5x15 zipper 3x16 Impression: layer…
HTD5 Timimg Pulley with 60 T for a 12mm Shaft (with 4mm Keyway) fitting on a dividing head. Printed with PETG and 100% infill.
Holder for the DTAPE DT50 Laser Distance Meter.
M5 Timing Pulleys for HDT5 belt 9mm width - 10mm shaft diameter. Mounted with a M3 setscrew and a M3 square nut
Can be printend without support. Printing time less then 2 hrs on my Ender3 v2 with: Infill: 100% Perimeters : 3 Bottom layers: 5 You can buy the DT laser here: https://s.click.aliexpress.com/e/_EGLouJf
Its a tool for holding the clutch when torquing the nut on a Yamaha DT50 engine. I used 6 walls, 5 top/bottom and 15% infill. This is probably overkill. :)
Clamp for Dickie DT57 Super Wheelz Based Autotransporter
Its a tool for holding the clutch when torquing the nut on a Yamaha DT50 engine. I used 6 walls, 5 top/bottom and 15% infill. This is probably overkill. :)
