5 models
This is a cover for the USB-C part of the SanDisk DualDrive o USB Type-C. It has a tight fit and thus a good hold that prevents it from falling off by itself. Use at a risk. Exclusion of liability for any damage or injury.
Ich habe mir einen DualDrive Extruder für Nema 17 Motoren konstruiert. Vorteil dieses Feeders ist, dass er die Gears linear aufeinander drückt. Er lässt sich einfach montieren und der Filament wechsel ist durch den Druckschieber relativ…
This DualDrive Extruder is mounted as direct drive with V6 hotend. The Tronxy X5S' original metal X carriage is kept to ensure the ridged hotend installation. Though, need to drill 6mm hole for the stepper axle if direct drive…
At least on my BMG copy has nearly 2mm gap between the secondary gear and extruder body (see the picture). This allows the filament load failure if tip of the filament is even a bit wrong way curved. This add on piece fills up the gap…
some BMG dualdrive extruder has wrong fitting. So it's better to center ptfe in it. You may use small piece of paper for it or you can print this bushing
