14 models
Replacement blades for the Durafly Auto g2 V2. The blades are designed to be printed in 3 pieces with ColorFabb LW-pla (regular PLA may also work). Print vertically with no supports, no infill, using the supplied config file. I found that…
Not quite a remix but the tray is based on work done by Rob Thomson. https://www.thingiverse.com/thing:1362079 Use SG90 servo for the tilt. There are two options for the pan servo (SG90 or TGY180). Print Settings Printer Brand: Prusa…
This is a FPV pod for the Durafly Efxtra. It features mounting for: Two 30.5 x 30.5 stacks for electronics Standard size FPV camera SMA connector Antenna tubes Magnet It's recommended to print the pod upside down. The reason for this is…
I designed these to cover the main and nose landing gear bays of my Durafly D.H.100 Vampire from Hobbyking. The wheels on this plane are small, thus landing on grass might lead to bent struts/pins. I hand launch and belly land the…
Replacement motor mount for the Durafly Monocoupe 1100mm RC aircraft. If you have a crash, the original motor mount is quite weak and breaks easily. This replacement part is much stronger. I printed mine in ABS with 20% infill, it is…
Remix of https://www.thingiverse.com/thing:4844369 This one is hollowed out so that it flexes slighly. I found that the other versions are a bit too stiff for the field that I fly on. Print in PETG 0.2 layers N.B. Mirror the files in your…
Made some replacement spinners and bases for the Durafly EFX-Racer. The injection molded parts are obsolete, so I made my own. This is a transfer from my thingiverse post: https://www.thingiverse.com/thing:4834966 Cone and base MK2 are…
Print vertically with supports. 100% Infill I used PETG for strength.
hobbyking efx racer canopy replacement, with bigger magnet hole to avoid loosing it again in high speed pass. just need to adapt the fuselage hole to fit better, mine was a bit chewed so the corners are not like the original.
Durafly Tundra landing gear support. The tundra's landing gear wire is made from regular steel wire which tends to bend out of shape from time to time. This part is to use when making your own improved landing gear from spring steel wire.…
This is a replacement for the standard latch on the excalibur. I used a 3mm knurl insert nut in the center. Print Settings Printer Brand: Prusa Printer: Prusa Mk2 Rafts: No Supports: Yes Resolution: 200 Infill: 25% Category: R/C Vehicles
The cowl on my EFX-Racer broke, so I modeled my own replacement.
Tailwheel Bracket Print vertically with supports 100% infill PETG
HobbyKing Durafly Hyperbipe firewall Print Settings Printer: Tronxy D01 Rafts: No Supports: No Resolution: 200 Infill: 20 Filament: Esun PLA + yellow Category: R/C Vehicles
