6 models
This is my redesign of the edgun leshiy magazine holder for use with M-LOK rails. I have a single mag holder version up here as well. This version has some subtle improvements over the original design. It is intended to be printed in PLA+…
I made the test prints in CF-ABS, so the tension might be a little different for PLA. You will need to print with supports as the underside is not flat. You will also need a pair of M-Lok screws and nuts. I also have a 2 magazine holder…
This is a fill port cover for the edgun leshiy fill port. It may fit other fill ports. It's designed to slip fit over the 14mm nut for the BSP fitting and protect the fill probe from dust and dirt. There are two lanyard holes for…
Attention! Requires a 3D-printer with height of a printing area 25+ cm Non-printing parts: 2 pieces of foam D = 2 cm * H = 1 cm are required in each half of the case. Внимание! Требуется 3D-принтер с высотой печати не менее 25 см.…
Recommendations for printing: material: PETG layer thickness: 0.2 mm Non-printing parts: Steel optical axis (D=3 mm, L=100mm, it can be removed from old CD drive, etc.) Self-tapping screws with hidden flat head M3 * 8 mm x 2 pcs…
Modeld after the drawing made by Mr Bond no supports needed print in a upright orientation print as strong as possible. it does have a modeld m6 thread use at your own risk
