Counting matching models…
Old-style Ekornes chairs had plastic friction matings on each side that allowed the chair to recline smoothly. The parts would break, though. This part replaces each half of the pair that were mated behind the knob. Make sure to sand the…
My Ekornes Stressless recliners were not holding in place well any longer. The issue was that the “pads” were worn out. Printer to the rescue. I designed these pads to bring new life to my recliners and I am so glad they worked! I printed…
This is a small collection of parts that I made to replace missing and damaged parts on my Ekornes Stressless suite. The plastic insert for the wooden sofa legs. This lifts the wooden legs off the surface by 3mm. Probably not needed for…
This is a replacement handle for adjusting the tension on a vintage Ekornes Stressless recliner. This works with the friction fitting here: https://www.prusaprinters.org/prints/82858-ekornes-stressless-friction-mating Insert a 3/8" hex…
I modeled & printed this Ekornes Sliding Ottoman Locking Pin to replace a lost piece on my in-laws footstool
Printed in TPU and using 6 pieces around the diameter of the circular base prevents the metal base from resting directly on the floor.
The remote control has very sensitive capacitive buttons. You can hardly touch them without one of the motors starting up. Operation without looking is not possible as the buttons cannot be felt. This cover eliminates the above-mentioned…
