15 models
Protect your precious Nikon batteries with this simple and “snappy” case! Printing Use the standard print settings in your favourite slicer. Make shure that “Minimum travel after retraction” (Prusa-Slicer) is set to 1 or lower I used eSun…
pasek do modelu 14 3dsets HDT 144-3M-06 drukować z tpu
When I printed the original by spontaniel I found that the fit was too snug at default size and the battery retention nub didn't work if you increased the size. Since this is all very hard to see in still images I recorded a short video…
There's not much to say: Nikon EN-EL14a Battery Cap -- I didn't like the other designs on Thingiverse. This design hat a small notch that keeps the cap from falling off. 2026-08: Version v2 has now a different "nose" to hold the cap on…
Keine Supports benötigt Aus PLA mit 20% Infill und 3 Perimeter
A simple battery pack holder for Nikon EN-EL14a type batteries. I wanted something quick and easy to differentiate dead batteries from charged ones on the fly. I printed the one in the photo with 0 top layers and 0 bottom layers with 31%…
A remix inspired by this design . Designed to work with Nikon EN-EL14/EN-EL14A batteries and SD cards.
This is a replacement front cap for the Sony SEL14TC and SEL20TC lenses. Original caps are hard to find, so I modified a front body cap to fit these teleconverters Prints without supports for easy production Can also be used on a Sony…
Este organizador modular ha sido diseñado específicamente para baterías EN-EL14 y EN-EL14a utilizadas en cámaras réflex Nikon. Ofrece versiones para almacenar 2, 3 o 4 baterías, con dos tipos de acabado: liso o con agujeros de ventilación…
CAREFUL WITH THIS! YOU MAY PERMANENTLY DAMAGE YOUR CAMERA! DO AT YOUR OWN RISK! I measured EN-EL14a to make permanent power source for my Nikon camera. EN-EL14a has protection mechanisms to be authenticated by the camera. However,…
Simple straight forward battery cap, snaps slightly into the groove. Use flexible filament like TPU.
This is a case I designed for an LP brand (cheap Chinese) EN-EL14 charger and two batteries that I bought on Amazon. I did this mainly because I was bored and wanted to work on my very limited FreeCAD skills a little bit. It's fairly…
This tower is designed to rotate the batteries through the charger. The hex cell weight reduction pattern saves filament. The batteries ride on internal rails to keep them from getting snagged on the hex. When printed in black PLA the…
fits four batteries, either the old EN-EL14 (black) or the newer EN-EL14a (grey)
Este organizador modular ha sido diseñado específicamente para baterías EN-EL14 y EN-EL14a utilizadas en cámaras réflex Nikon. Ofrece versiones para almacenar 2, 3 o 4 baterías, con dos tipos de acabado: liso o con agujeros de ventilación…
