Counting matching models…
Enclosure for the Shelly Humidity & Temperature sensor. Use it to have a more wather proof Shelly outside your apartment. Print the two halfs (bottom and top), put your Shelly inside the bottom half and screw the top half on top of it.…
Full-featured case for GM328A TFT Transistor tester variant and 18650 Li-Ion battery. Charger module is Q3962A with attempt at light conductors for it's indicators (and it actually works). Step-up module is MT3608. Knobs are from some…
Front subwoofer enclosure for a MK7 Golf (left hand drive). Designed for the SB Acoustics SW26DAC76-3-DV. Version 1.1 is the one I ended up using, and added 1" of plywood on the front to make it stronger. If you have an incredible amount…
This is a magnetic center foot for the Prusa Enclosure. For use with 8mm X 3mm Magnets.
Ich habe eine Modulare Werkzeugleiste erstellt. In meinem Fall ist diese auf den Ikea Schrank Platsa (Lochabstand mm) dimensioniert. Durch die Fusion 360 Dateien aber individuell anpassbar. Das System besteht aus der Grundplatte…
This is an enclosure for the Mister fpga project with encosed usb,analog io board,memory,and power supply. almost all parts can be printed with out supports. all measurements are in imperial. I printed this with ABS on a reprap mendel…
Just a simple slide lid enclosure for my 5vdc to 120vac relay switch. I connected it to my laser engraver to turn the air pump on automatically. Its a tight fit but if you have 3 hands like i do then you can wire it. lol. Its not bad.…
Just a simple slide lid enclosure for my 5vdc to 120vac relay switch. I connected it to my laser engraver to turn the air pump on automatically. Its a tight fit but if you have 3 hands like i do then you can wire it. lol. Its not bad.…
No support required brackets for the back of a 32022 Bud enclosure that snaps onto 1/2" pvc pipe.
