9 models
I love my Omnifixo clamps. They are so far the best third hand I have found. But for clamping some objects it would be helpful if the clamps could be on different heights. Sure, you can stack the yellow parts of the clamps, but as there…
I have taken this idea from the "Multigrid Bin Extension" by Keep Making. and adapt it to the gridfinity system. This allows to extend the length of already printed bins with out reprinting them. I have made an parametric model in Onshape…
I needed more space for my fans to breath so I designed there feet extentions that use the stock feet and screws + 8x m4x25 machine screws and 8x m4 nuts and washers I desigend it to raise the printer 50mm but I didn't account for the…
If you find yourself reaching for the knobs below the screens often, but they seem just a tad bit too short to be comfortable to use, I've got you covered! These extentions should pressure-fit right onto the existing knobs, and if you…
The magnetic holding strength is significantly weaker than using the stock bases as standoffs. I recommend using a stock base for the top and bottom of your stacks.
Leg Extensions for IKEA Metod Legs https://www.ikea.com/ie/en/p/metod-leg-70556067/
I cant remember/find where i got these from originally. good simple stick extenders for increased fidelity on the sticks. Category: R/C Vehicles
Extend the legs of LACK table from IKEA to fit bigger stuff under it like in the photo.
If you find yourself reaching for the knobs below the screens often, but they seem just a tad bit too short to be comfortable to use, I've got you covered! These extentions should pressure-fit right onto the existing knobs, and if you…
