Counting matching models…
This is a remix of the awesome looking OctoGlasses from Ramalama2 which fixes some issues in the original design. Design There are the following changes: The terminal cover on the left side of the board is now fully accessible The fans…
Finally printed the BentoBox recirculating airfilter and made some changes to it and some nice cable management inside the P1S for 12V. I use the filter mainly when printing ABS/ASA to avoid VOCs and that nasty white deposit that…
BTT Octopus Fancase that can be screwed from the top.
Adjusted the right side to mirror the left cutout in order to expose the 5v and GND rails on the Octopus. This allows you to run a DuPont connector where previously it was blocked by the original midpiece design.
Uses standard Voron heats in the fan case versus in the actual fans.
For detailed information - please check original model
i remixed the design below. i needed it to fit my layout better so added the changes to mount it sideways live print of model : https://www.youtube.com/live/Lc525G2sB8k?si=7tu_PqtjlUgb3SB8
For detailed information - please check original model
I have modified the original model to accommodate three 4010 fans. Additionally, certain areas have been thickened to improve structural rigidity. notes:1.Connect the main power cable to the motherboard first; however, note that this may…
I have modified the original model to accommodate three 4010 fans. Additionally, certain areas have been thickened to improve structural rigidity. notes:1.Connect the main power cable to the motherboard first; however, note that this may…
