Counting matching models…
This is a remix of LtDan's printable trumpet, with just a few modifications. I've reworked the tops of the valves to give them screw-on caps, which are themselves designed to be printed in two parts (brass/gold, and white), so that you…
This model includes a couple of tweaks from the excellent original. My d20s were jumping the rails so I made them about half-again as tall. I also felt it looked just a bit plain next to the Tardis model, so I added a subtle brick…
0.12 layer height, Arachne wall gen, no supports
A Drip Tip for Uwell Fancier. Printed mine in 0.08 Category: Other
This is a frame made specifically to accommodate two of the double-sided Super Smash Bros. posters being handed out for Free at the Nintendo Store in Tokyo.It’s made to be just barely smaller than the poster itself in order to allow it to…
Built this when the original set of STLs for Lava Leylines didn't include the lava insert for some reason. I put some nice little bubbles on top, so it's a little more pretty and thematic.
For the full guide see this gallery: imgur.com/a/8uXmRhu I had a design I wanted to apply to my SO. It was too complex to draw and redraw and I didn't want to pay for temporary tattoos printed with it. So I made a 3d Printed Stamp. I used…
