Counting matching models…
extra shells for your flypoint blaster, also works with https://www.printables.com/model/246775-nerf-superflare-adapt-kit found it here: https://shellingtonlabs.com/shop/flypoint-shells-for-half-length-darts/
This is a remix of Shellington's Flypoint shell. With a slightly beefed up rim, it run smoother than the original 3d printed shell, on par with the injection molded counterparts. Thank you Shellington Labs for the genius engineering and…
This is a frontend, and will need to be printed with some supports. Orient it so that the 45° marks on the picatinny are so that the picatinny will not need supports. Use supports on the build plate only, and I like to use snug. This has…
A really simple holder accessory for (Flypoint/ Kirin) shells and also Ultra Darts (they don't get squeezed). It attaches on picatinny, available in two length. I may had more options in the future. You need a 3mm elastic string, or any…
UPDATE 02.01.25: added .STEP file, the 7 round capacity with holes. UPDATE 01.01.25: improved the follower's design These are based on the original geometry, so they should be compatible with the Kirin type A, the Wrenfield and the…
This is a drop in replacement for the Nerf Rival Pilot to allow it to utilize flypoint shells, it has spots for O-rings (which are not strictly necessary, but will greatly increase performance and make it more consistent).The long tube…
Holds 18 Flypoint shells for Shellington blasters in generic ammo packaging There is a tolerance of 0.3mm. For me, the shells slide in just perfectly Print the Template.PDF below in A4 size paper for the packaging displayed in the images
This is my own model based on/inspired by this design https://makerworld.com/en/models/422367?from=search I made this because that design does not fit in the a1 mini. I was too lazy to design it to be specifically be stackable. I suppose…
This is the popgoblin, its like the target goblin but with shells. Assembly is exactly the same as the regular goblin, you just need to add one extra o ring, a dash-123 (AS-568-123) the same as used in plunger tubes. The fps is a bit…
this is the UPGRADED piccaatiny shell holder for flypoint shells! it gets bigger stronger and higher! i would definitly print this one bcauze it could also fit on ver small rails like on the sklep. layer height: 0.2 infill: 20%-90% i…
This is my own model based on/inspired by this design https://makerworld.com/en/models/422367?from=search I made this because that design does not fit in the a1 mini. I was too lazy to design it to be specifically be stackable. I suppose…
![Flypoint Shell Box [18 Rounder]](https://media.printables.com/media/prints/8965cedd-1e05-4b0e-b600-f1d3f8281bc4/images/10011958_ddca854f-084b-4951-a7c1-f7e5140ee7be_1bf9aea3-83e5-4095-b635-95d7ee3de145/img_20250614_034003.jpg)
