15 models
Ford Focus MK4 brackets to stick the Aliexpress ambient footwell LED's on. The brackets will fit into the original mounting positions where normally the factory ambient lights will be installed. Somehow left and right have a slightly…
Print approx. €0.89–€1.08 excl. taxPreliminary estimate for one variant
hook around the top in combination with VHB tap around the edges for a tight seal.
Clips in under the front seats to light the rear seat floor. Checked the fit on my Ford Focus MK4. Installed for the AE ambient light kit: https://a.aliexpress.com/_EHuvyLl
These are vent cover that I designed to make the footwell vents in my Midget easily accessible, as I was tired of fumbling around at traffic lights, trying to open the vent covers. These make opening/closing the vents easy, with the 10mm…
MX5/Miata USB Type B footwell panel
This is a footwell light cover designed for SEAT cars with the prepared plastic installation (car in pictures is a ibiza style 2018). Cover is designed to fit following T10 bulb holder ( https://a.aliexpress.com/_mOOa56w ) and T10 led…
This is a fuse box cover I drew up to finish a dash cam installation job I did for a 2026 Lexus TX 350. You will need to print this in ABS. You need tree supports on the build plate only, along with impeccable bridging performance on your…
This is a footwell vent for a 1972 MGB. It’s likely to fit other years since they used the same parts for a while. It’s printed in ABS for durability and uses snug supports to prevent drooping.
the pin insert must be printed on the side so that the teeth can be supported . 100% in fill but it's so small u can't do less by mistake must be printed in ABS/ASA to withstand the high temperature inside the car and i think it's easier…
A lamp cover to replace the one that is above the footwell on the underside dashboard cover. This may fit other places. Print vertically standing up on the flat end. Use tree supports. Use transparent or translucent PETG. You may buy it…
use press wire connectors as in the pics and glue it using super glue the difuser is press fit so you don't need to glue it ...just push it in connect 2 wires earth and positive to the interior lights cables then press it in place above…
Toyota Century G50 - Footwell Air Vent Cover Anyone else missing the air vent cover on the front footwell area of your second gen Toyota Century (G50 V12)? It looks like they don’t make them anymore, so I did a quick design that looks…
use press wire connectors as in the pics and glue it using super glue the difuser is press fit so you don't need to glue it ...just push it in connect 2 wires earth and positive to the interior lights cables then press it in place above…
These are vent cover that I designed to make the footwell vents in my Midget easily accessible, as I was tired of fumbling around at traffic lights, trying to open the vent covers. These make opening/closing the vents easy, with the 10mm…
This is a footwell light cover designed for SEAT cars with the prepared plastic installation (car in pictures is a ibiza style 2018). Cover is designed to fit following T10 bulb holder ( https://a.aliexpress.com/_mOOa56w ) and T10 led…
