Counting matching models…
This is a mobile phone case for the Fxtec Pro1 and Pro1x models. There are slight differences between the two. USB and fingerprint reader locations. Screen protection is the same on both. It features a small lip around the edge to match…
This is a wheel cap for a Kawasaki Mule FXT-pro. I made if for a 2020, but it will fit many years. Kawasaki wanted $25 a piece, so I guess I outsmarted them. Made it out of black PLA+ at 100% infill. I turned it 90 deg in Cura so it sat…
These will raise your ground clearance by approx 10mm, and allow maximum axle articulation on both sides. More than90 degrees! Should also work on Danchee Ridgerock and Pirate Swinger 0.1 layers 100% infill 220C for the filament 70C for…
This is a FPV pod for the Durafly Efxtra. It features mounting for: Two 30.5 x 30.5 stacks for electronics Standard size FPV camera SMA connector Antenna tubes Magnet It's recommended to print the pod upside down. The reason for this is…
A remote holder for "old school" SANYO TV remotes circa mid-2000s. This will not work for all SANYO remotes. This could work with other remotes, both SANYO and non-SANYO, as long as they fit within these dimensions: Between 30.5 and 46.5…
Third person FPV mount for the wltoys k989 (will fit other models) using a FTX cam01 FPV all in one camera. Camera mounts on the rear of the base plate using the two unused screw holes. Print Settings Printer Brand: Creality Printer:…
The FXT Viper screen when mounted into the googles cannot use a standard SMA thumbscrew adapter as the goggle gets in the way so I designed these so you can easily get the antennas off and on. I did a larger grip area for your normal…
Holder for an FxTec Pro1 phone, complete with routing for a charge cable. The required cable is this one: https://www.amazon.co.uk/gp/product/B01GGKYR2O/ . Category: Mobile Phone
