Counting matching models…
This is a single-axis servo gimbal designed for the 7/8/9/10inch Mark4 V2 frame. It allows you to tilt your FPV camera up or down and can also provide stabilization during flight. The build uses an ES08MDII servo, though other similar…
A 3D model of a passive stabilizer, which operates without electronics, represents a mechanical system designed to maintain stability through physical means. Such models are often used in engineering and physics to study the behavior of…
Beacause reasons! Its important that you print the gimball in fine 0,1 or better or the inner gimball wont break loose and it wont move like its supposed to. Dont print wirh a brim and also use support material. PS ! Pay close attenten…
Hi all! Here is my remix of another design posted here on Thingiverse. Made the mount compatible with the DJI O4 Pro, which bolts on the rear, and a 5V fan bolted on the front. The C20T gimbal sets as previously designed, with an airspeed…
So is the logo on the new macbooks the right way up, or upside down? Some say right way up, because it's the right way, when the macbook is open. I say, that I payed for it, it should be designed for me, and I see it as upside down just…
Simple design but effective. Protect your most important radio parts.
The standard gimball protector has not a sufficient height when using an extended stick. Therefore I designed a special version with a total height of 60 mm.
A multifunctional gimbal and phone mount that can be 3d printed and used by common people without any effort.
I put only the left ring so to print the right one, just do a mirror inversion in your slicer. Set them up on your radio only by replacing the older ones, there are the same dimensions. I give the fusion 360 file if you want to modify…
updated for gimballed feature, added more compliance. Printed pieces separately and assembled easily by hand.
I put only the left ring so to print the right one, just do a mirror inversion in your slicer. Set them up on your radio only by replacing the older ones, there are the same dimensions. I give the fusion 360 file if you want to modify…
Hi all! Here is my remix of another design posted here on Thingiverse. Made the mount compatible with the DJI O4 Pro, which bolts on the rear, and a 5V fan bolted on the front. The C20T gimbal sets as previously designed, with an airspeed…
