Counting matching models…
Simple guying line spooler. I made it for my amateur radio station. You may also use it for kite or as a general paracord spooler. Print instructions Thin version is 5mm, thick is 7mm. I printed this from PET-G.
A summits on the air guy winder + tensioner for guying your mast. Are you tired of you guys or cord used for guying a mast getting tangled with each other ? This is designed to provide an adjustable guy with a winder to wind the cord when…
Guying rings for attaching guywires to various masts 38mm version made for standard metal mast pipes. Can be printed a few percent smaller to fit only at the joint between two sections, or held in place by hoseclamp or duct tape. 12mm and…
This plug is used to secure the toggles of the new Buddipole injection-molded guying ring.
Guying ring to support the Sota Beam Tactical Mini mask, inner diamater is 30mm, print with a large number of walls for maximum strength.
Lightweight set for portable antenna setup only 22gr for all elements in TPU Set was designed to be as light as possible, with decent ammount of strenght, and for minimum ammount of guying rope to be used. Designe is intended and printed…
Guying ring for Carbon 6 mast. Attaching height about 2m from bottom. Designed to “catch” junction point of both 7 and 8th section from bottom, so it uses reinforced sections. Rope holes 4.5mm. Tight fit around sections, depending on your…
A lot of folks use the Goture Tenkara rods as cheap, light, and portable antenna masts. The bottom cap of the rod is rounded and it can slip around when guying. I wanted to create something that could be left on all the time but still…
Lower is a little larger ID for lower sections of mast, Upper is a little smaller ID for higher section of mast. 3/8 holes, 120 degrees apart.
Necessity is the mother of invention. I needed a good way to help me not only guy up my mast but also make it slim so I can pack it in its bag the mast came in. I made a lip on the top edge so the collar is locked at the end of the tube.…
This is a 36mm collar for use with a MS-44/AB-155 antenna mast. Perfect for replacing a missing guying attachment point.
Guying plate with 3/8 " center opening. Works with chameleon extender poles and other vertical antennas
