Search results: hdt

3dsets belt model14 max HDT 144-3M-06

pasek do modelu 14 3dsets HDT 144-3M-06 drukować z tpu

Heat Deflection Temperature (HDT) tester V2

This is an updated model to be used to measure the Heat Deflection Temperature (HDT) of a 3D printing material. The test can give results close to the ISO 75 HDT/A and HDT/B that are commonly found on technical datasheets It is to be used…

HDT5 Timing Belt

HDT5 Timing belt - 11 mm width, 400mm (80 T) length. Printed with TPU Extrudr Flex Hard

HDTV Antenna (OTA DTV)

I designed these mounts to zip tie to a standard 1" diameter PVC pipe or wooden dowel (a piece of old rake handle in my case). This DIY DTV antenna works better than the store bought flat flexible square antenna I was using in my attic…

HDT5 Timing Pulley

HTD5 Timimg Pulley with 60 T for a 12mm Shaft (with 4mm Keyway) fitting on a dividing head. Printed with PETG and 100% infill.

HDT5 Timing Pulley M5

M5 Timing Pulleys for HDT5 belt 9mm width - 10mm shaft diameter. Mounted with a M3 setscrew and a M3 square nut

Electric longboard pulley hdt3m54t

Hdt3m pulley with 54 teeth for electric longboard. Pulley uses these wheel adapters: https://www.thingiverse.com/thing:2969654 Pulley dimensions: Diameter 50.5mm Width 12mm Middle hole 21.5mm Holes and screw head sink are for M5 hex…

Heat Deflection Temperature (HDT) tester V1

EDIT: SUPERCEDED BY V2 https://www.printables.com/model/1055576-heat-deflection-temperature-hdt-tester-v2 This is a model to be used to measure the Heat Deflection Temperature (HDT) of a 3D printing material. The test can give results…

42 tooth Onda drive sprocket for electric longboard HDT 5m

At 14t on a motor and 42t on the wheel, you end up with a gear ratio of 1:3. I imported an stl out of openSCAD after setting up the HDT 5M parameters, then added the flanges to mount to the onda motor. I'm very amature at 3d modeling, so…

Trampa_MBS_Wheel_Pulley_HDT5_Esk8

Small HDTV Antenna Mount

This is a tabletop mount for the Small HDTV UHF antenna. Print Settings Printer Brand: LulzBot Printer: TAZ 5 Rafts: No Supports: Doesn't Matter Infill: 20% Category: Electronics

Feet_For_HDTV

so i went out and bought a 55 in smart tv and it didnt fit my tv unit, so i had to think fast and knocked up these freestanding feet. used on a tcl make them strong after all you dont want your tv on the floor buy me a redbull pp…