Counting matching models…
Designed this to fit a Whirlpool ice maker includes an insert that drops into the tray that can be replaced when stained or dirty. Print the insert on a textured sheet to help hide the water stains.
This is a replacement lever arm part for a Samsung moveable ice maker. Category: Replacement Parts
This is slightly modified version of the Samsung Movable Icemaker Lever Arm Replacement Part . Changes include: Reduce width of part Replace fillet with chamfer Shaved a little off the locking shaft Extend handle shaft length by 2mm…
this model holds the ice scoop for a hamilton beach counter top icemaker. attach using command strips.
The part is very small so I recommend to print it with 3 or 4 perimeters and 100% infill I prefer PETG because PLA is too brittle, specially at -21ºC
Samsung mobile ice maker lever arm replacement part separated into 3 parts so it prints without supports
This is a replacement part for a GE Profile PSRS6PGZSS ice maker. This stops the ice cubes from sticking to the fingers that push the cubes out of the cube tray. The tabs on mine broke so I measured and remodelled. The original model…
I broke the ice maker switch in our old side by side GE refrigerator. Fridge has since been sold so I don't remember the model but was within last 5 years. I measured and printed this out to allow us to turn off the ice maker again. Works…
Adapt .25 OD plastic pneumatic/icemaker tubing to PC4-01 BSPT Thread. Works with Sunlu FilaDryer Filament Dryer S2 PTFE Adapter by MichaelQ Update: Works best using PTFE bowden tube as a liner inside the length of your nylon tube.
The deck of the in-door ice/water dispenser of my built-in GE monogram refrigerator broke. I replaced it with this, which fits perfectly and is far more rugged than the original. The gray color even resists showing hard water marks.
Just a facia for an icemaker for a built in fridge i made for a mate. print as on plate and use connectors and glue to join
My KitchenAid icemaker no longer rotates when you use the ice lever. The teeth on the icemaker that spin the rotating mixer no longer latch on to the hex nut that connects to the freezer. This "snugs" up the teeth on the ice container to…
