Search results: ilford

Counting matching models…

Ilford Multigrade Filter Holder for Meopta Opemus 6 Enlarger

This filter holder slides onto the D shaft below the lens where the red safety lens usually is. Category: Parts

Downloads: 165
Likes: 13
Rating: 0

Liesegang Rajah IV Ilford Multigrade Filter Holder

This thing was made with Tinkercad. Edit it online https://tinkercad.com/things/hn8a9pwTwkK Instructions This is a filter holder that will fit Ilford filters. It will replace the red filter on the enlarger and therefore it may be fitted…

Downloads: 100
Likes: 13
Rating: 0

Order a print of this model

Printablesfedon

Ilford Filter Holder

A copy of the Ilford contrast filter holder for darkroom enlargers. To assemble you need 3 x M6*35 bolts and the corresponding nuts.

Downloads: 37
Likes: 6
Rating: 0

Order a print of this model

PrintablesEthereal Film Store

Ilford CAP-40 RA4 Modification Pulley

These two pulleys are designed to increase the roller transport speed so that each bath is reduced from 2 minutes to about 45 seconds. It also utilises the original pulley belt from the processor, so don't need to buy a new one. I printed…

Downloads: 23
Likes: 1
Rating: 5

Order a print of this model

PrintablesJoeB

35mm film holder, for Kodak Fujifilm, Ilford,

Just a 35mm film holder, holds 3 rolls. I cut some thin foam and glued it to the bottom of the main body. This helps reduce any rattle printed using PLA, shrinkage from other materials not taken into account