Counting matching models…
First version of facemask using a coffee machine filter paper as a protective layer between you and small virus infested droplets in air. If you want to colaborate in development, please contact me.
This is my take on cheap, improvised hand saws which may be useful for your 3d printing workshop or due to their small size and low weight as a camping tool. It uses 2 M4x10 bolts and nuts, however to further simplify it, using superglue…
... in case you run out of toilet paper ... Category: Bathroom
Please read summary! Make sure to check support settings. I belive I had them off by a little. I included the files from the other users in case someone chooses to use theirs instead. The one I modified is listed (mine) in the…
The latch from the creator, broke many times. I thicken the part the part/latch. remix of a remix Where I got it from (Betafpv Pavo Pico O3 Case) by Daniel_Schenk https://www.thingiverse.com/thing:6103644/files Original Latch…
Technically just a lazy remix of the latest OpenLOCK clip from the linked OG design. My DM and I set out on a 3D printing journey to make a nice little modular map for a campaign that we are in and I was persistent about not needing walls…
For printing it on the Prusa XL. I joined the two sides with 16 mm PVC pipe cut to length and glued. It makes a portable ramp, better than the alternative.
A small improvised light stage using a cellphone (fitted for iPhone 8 with cover). The top is a plastic standard Petri dish, which I sanded a bit to disperse the LED. I plan to glue a piece of polarizing foil to the inside and use this in…
Make a rack/organizer with any flat surface, make 7,5mm holes on any suface and stick these bad boys in, as seen in the picture you can stack'em, is meant to be a temporary fix. I'm using TV mount plates as the diferente levels, but wood…
This is the Improvised flail when you want to defend you're Self To set up grab you're cord "paracord reccomended" Then put the cord tru the hole then tie a knot at then end and bam you got a "toy"
I really like what RockStarAlchemist did with the case, but wanted one that would accommodate the mullet mod (which removes one battery section) and would also be less tall (because it didnt need AS much height). notice…
I recently picked up miniature painting again and got bored shaking all the paint bottles by hand after standing around for a while. Since I didn't want to wait for the vortex mixer I ordered (which performs better..) I very quickly drew…
