Counting matching models…
🎄⭐ Print as is, no supports and layer-height .15mm (the lower, the better, as it results in more stable overhangs. More than .3mm and model will not slice correctly), 100% infill. Also you might need to slow down your speed as this model…
Игла для надувания фитнес-мяча
Reductions for inflating SUP (inflatable ruber BOAT) by 20V CORDLESS COMPRESSOR AND AIR PUMP. 1 reduction is for AIR PUMP 1 reduction is for COMPRESSOR - this needs CAR VALVE with G1/8" (thread printed in model) Connecting surfaces needs…
The receptacle part of a self inflating mattress where the valve plugs into the mattress. Printed with garbage creality green pla.. rubber cemented in place.. holding up sofar.
The reducer is designed for a paddleboard pump. There are 3 sizes available: 8 mm, 9 mm and 10 mm. You can use for inflating, mattresses, rings and other water attractions. The supports are used in the printing process only for the pins…
I didn't want to buy a new pump just for this mattress, so made this adaptor to use a pump I already had. Made for the Outdoor Revolution Skyfall Midi 150mm Self Inflating Camping Mat ORSM2013 It took a couple of revisions to get it to…
This adapter enable to use the SUP air pump to inflate your airbed. For my pump the seal is surprisingly good, no additional o-ring required. Be careful with the air pressure, to not damage your air bed. The SUP pump is very efficient and…
I bought this great Alps inflatable bed for camping and for guest use. The problem is that the switch comes on too easily if something bumps into it during transport. Then you arrive at your destination with dead batteries in your pump or…
This is printed in TPU to match the soft seal the original bag uses; however, if it works in anything else, please feel free to share in the comments. The sleeping mat I have is the Coleman Supercomfort Self-Inflating Sleeping Mat 12cm…
With these adapters for the Fanttik V8 Slim, you can inflate and deflate pool floats, air mattresses, and similar inflatable toys. The nozzle is required for both functions and is simply attached using a bayonet connection. The nozzle has…
fits (electric) pumps with Outer Diameter of: 35mm printing suggestions prefer softer material like PETG print with high perimeter/wall-strength count prefer wider nozzle your suggestions are welcome still looking for ways to improve the…
