9 models
IPEVO V4K Camera Arm Extension This is a two-segment arm extension for the IPEVO V4K series of document cameras. I have only tested it with the "Pro" version of this camera, but it should have the same dimensions as the normal one. You…
Riser stand for IPEVO Do-Cam which permits viewing a full 8.5"x11" document. Slides over the long side of the base. Printed in PLA, no supports needed but could benefit from supports on the buildplate only, 25% infill, minimum 2 exterior…
An extendable arm for a document camera. Requires two m3 screws ~ 18mm in length and two nuts.
A dock and desk tidy to provide safety against knocking the visualiser off your desk - just cut two pieces of nano tape and place them in the two recesses in the base. Print Settings Supports: Yes Resolution: 0.3 Infill: 25% Category:…
This is a sleeve that holds an IPevo HD Plus camera on any VESA-compliant monitor/TV mount. I use it to hold the overhead camera above my desk, get additional height, and most importantly keep it out of the way when I'm not using it. This…
this replaces the x axis stepper cover/limit switch mount and has a small mount for the top portion of an Ipevo v 4k document camera. This model uses the same mounting screws as the original cover. Compatible printers: Ender 3 v2 Neo, and…
This is a base holder for the IPEVO VZ-R document camera. It's compatible with the original screws (with a few mm added for clearance). Because most filament is very light, it doesn't work well on it's own as a base – it doesn't weigh…
2nd & 3rd photos show a slightly older prototype I had made, this design is virtually identical other than being stronger & takes less time to print. 50% or more infill is recommended. Supports are recommended for the V4K attachment point.
A clip that keeps the neck and cable of the IPevo VZ-R or VZ-X in place when being stored or packed for travel.
