Counting matching models…
This subwoofer features a large triangular port, a hallmark of most of my designs. Its generous volume and dual drivers, which operate mechanically in parallel, allow it to achieve a low-end extension down to 45Hz and even lower, perfect…
This is a mounting bracket for a TrippLite ISOBAR4. This is designed to be mounted either horizontal or vertical - either way should be fine. https://www.amazon.com/Tripp-Lite-Protector-Right-Angle-ISOBAR4ULTRA/dp/B0000513O4 I quickly…
A voroni patterned grille to match the bookshelf speakers I designed Made to go with the rest of this design: www.thingiverse.com/thing:4765663 Print Settings Printer Brand: Prusa Printer: I3 MK3S Rafts: No Supports: No Resolution: 200…
Thanks @guppyk for the design. ATTENTION the .stl file is only included to satisfy the Thingiverse file restriction, as 3mf files are not solely supported. I just adapted the mounting bracket, the box and the upper spacer to fit the…
A wall mount for Tripp Lite 6-outlet Isobars. Supports screws or command strips. 2 Large M3 command strips seem to hold it well. If you go with command strips, make sure you apply them and allow them to cure before mounting the isobar. No…
Print as imported - friction fit installation. Surge protector will require two covers. Intended to cover keyhole slots on bottom panel when not wall mounted.
I printed two of these to mount the surge protector onto my network rack magnetically using neodymium magnets. (one print for each set of two keyslot mounting holes) I have not tested this vertically so you may need stronger/larger…
Use a ziptie through each to secure the power brick to the clip & press fit onto the table leg.
