Counting matching models…
For KingKong RC Lurker. Side vents to be printed with 0 top layer (infill according to taste) then glued with silicone to make the pocket behind watertight. Category: R/C Vehicles
Taillight for KingKong RC Lurker. To be printed clear or translucent of course. Snaps into place (a bit on the tight fit side) Category: R/C Vehicles
Videos of the Sherp show some equipped with mud flaps running all along the sides and extending to the rear. Sides are not needed and wouldn't be easy to connect to the Lurker but rear extension may help limiting water splashes to enter…
Wanted to offer some fresh air to my ESCs. Requires a modifier of max 116x44. On the modifier, set top and bottom layers to 0 and set your infill to taste (I've used Honeycomb at 25%). 9mm and 5mm heights available. Clip-on like original…
Videos of the Sherp show some equipped with mud flaps running all along the sides and extending to the rear. Sides are not needed and wouldn't be easy to connect to the Lurker but rear extension may help limiting water splashes to enter…
I liked the original but I don't plan to use the roll cage and don't like to have all these screw poking. This remix is to be glued with silicone. Category: R/C Vehicles
