15 models
Uses m6 (30mm) bolts and lock nuts to hold into place. If you need to fit a larger (1/4) you can melt the nut into the base. I have printed with 20% and 10% infill, holding up well. I print in abs or asa. Print Settings Printer Brand:…
This part is used as a spacer between the Black Box Embedded Magnetic Mount and WunderLINQ to allow large phones to fit in the BMW RT or K1600 dash. You'll also need four stainless steel M4-0.7 35mm cap head screws. Print Settings Rafts:…
Instead of purchasing another overpriced cooler for my Seadoo, I decided to come up with a cheap alternative. Screw jack attachments slip easily in the rubber feet on the Yeti Tundra 35, and relatively inexpensive LinQ brackets can be…
1. Lore & Background for “Relinquished” in D&D 5e Relinquished is a fascinating creature to adapt because of its eerie, parasitic nature in Yu-Gi-Oh. Here’s a concept for its lore: Name: Relinquished Type: Aberration (or Fiend, depending…
Can-Am (715006097 ) LinQ 30 US Gal (139 L) Trunk Box to Fit without removing rear rack. I bought this box for my atv. It was annoying that it needed to remove rear rack to make this fit in linq system. I made adapters that make it…
Tiskněte s plnou výplní (kdyby něco nesedělo ať se to dá doladit např. úhlovou bruskou či nožem)
Holder for cans, fits Can-am atvs with linQ racks or any vehicle that has linQ mounts. 2 versions are included, one is for thin cans (ca 58mm) and one for thicker cans (ca 67mm) Fusion 360 files (.f3z) are included for own customization.…
This is a spacer for installing helper hinges on the CanAm LinQ 32gal trunk. With the helper hinges installed the lid stays up without the need of the flimsy kickstand. The spacers are needed because the holes in the helper springs are…
A dual battery system for a Can-Am ATV for winter use and for accessories that draw a lot of current. It takes same size battery, that is original outlander battery. I have it on my Can Am Outlander HD7 G3L Hardware needed Battery…
This is an adapter plate for the WunderLINQ phone holder to use with your existing BMW Motorcycle Navigation Prep that allows you to control your smartphone with your handlebar wheel.This piece is the part that gets attached to the phone…
These are spacers for the Linq system mounts. This is mounted on a 2026 Maverick R. Print these at 30 percent Gyroid in ABS. Put the 14mm spacer to the front of the SXS. And the 9.5mm at the rear. Use 1/4 inch nutserts in the cooler. And…
This mount is on a CanAm Gen2 Max with the rear seat removed. The base plate and pieces that locate the saw are plywood that was hand-fitted, no drawings. But the various printed parts might be useful to others building similar mounts.…
Attach to bottom of your accessory with a self-tapping screw, insert through linq hole, rotate 90 degrees and tighten screw. To remove just loosen the screw slightly and rotate the nut so it lines up with the linq slot.
LinQ handle in TPU 95A that doesn't break. Printed with 60% infill. Available for both right and left sides
