Counting matching models…
This should fit a standard ADXL screw spacing and is designed to clamp to the print bed and axis of an Ender 3 with a magnetic plate on the bed. I also have an orbiter 2.0 extruder on a custom mount. It has been designed with this module…
There are three mounting options for the accelerometer: vertical, horizontal, and diagonal. Pick the best one for your needs, and install brass inserts accordingly. For all mounting options, the mounting holes are 15.5mm apart. So you can…
The mountig holes are for 3Ms heated inserts and a short m3 screw for the hot swap mounting point. Just slide the Case with the sensor underneath the screw and tighten it down. i also used a long m3 screw for stabilizing the Bracket for…
Got the Mellow Fly-LIS2DW and needed a mounting bracket for the end of the nozzle. Just about over the RP2 chip
It is a very quick model that I've designed just because I ran out of a double-sided tape. It works all right. Furthermore, it's meant to utilize 2x m3 and 2x m2 or 4x m3 heat inserts. Dimensions of the wholes are shown on the picture above
For BOM and assembly instructions refer to the excellent diagrams by LMaker with the exception of one additional M3x25 replacing one M3x20. The original works great for a traditional bed but a 6mm bed with magsheet, buildplate, heater,…
printed mine prototype with PLA 30% infil.
I designed this mount specifically for use with the quick release fan duct system: https://www.printables.com/model/724096-anycubic-kobra-2-upgrade-plus-kobra-2-pro-kobra-ma Print settings Layer height: 0.16mm Infill: 100% I recommend to…
Base for using this type of BTT brand accelerometer. The idea is to press the piece against the front of the bed. If you have a magnetic base and plate, the measurements may vary. In that case, you might need to file it down to make it…
Base for using this type of BTT brand accelerometer. It can be used with the EDDY cable mounting bracket, which you can find on my profile. 100% Infill 0.2 Layer M3 inserts (2 units)
Base for using this type of BTT brand accelerometer. It can be used with the EDDY cable mounting bracket, which you can find on my profile. 100% Infill 0.2 Layer M3 inserts (2 units)
